911爆料网

High pressure spray cleaning machine is a matching assembly line equipment that allows materials to be fully dispersed, rolled, and cleaned under the action of high-pressure water flow and bubbles after entering the water tank, and then transported to the next process through a conveyor belt. It can be widely used to clean various agricultural and sideline products such as fruits, vegetables, mushrooms, edible fungi, and seafood. It is an advanced equipment in today's vegetable processing, food, catering, and other industries, greatly improving production efficiency in industrial production.

从物料表面洗脱的污物会沉入底部隔离池，洗净的物料出水后再经喷淋清洗，使洗净率高且不会发生翻扬回流造成再度污染。该机自带水循环系统，清洗槽盒低贮水箱中的水经高贮水箱过滤后，由离心泵加压再输入水槽，所耗水量较低，符合节水要求。

The dirt washed off from the surface of the material will sink into the bottom isolation tank, and the cleaned material will be discharged and then sprayed for cleaning, ensuring a high cleaning rate and preventing further pollution caused by overturning and backflow. This machine comes with a water circulation system. The water in the low storage tank of the cleaning tank is filtered by the high storage tank, pressurized by a centrifugal pump, and then fed into the tank. The water consumption is low, which meets the water-saving requirements.

高压喷淋清洗机使用方法：

Usage of high-pressure spray cleaning machine:

（1）接好电源线。应根据电源的标号对应链接。严禁380痴与220痴错接。

(1) Connect the power cord properly. The link should correspond to the label of the power supply. Misconnection between 380V and 220V is strictly prohibited.

注：加水前先检查风机是否顺转然后加水，加水后再看输送带电机、水泵是否反转，如倒转，停机换线，严禁错接。（未接对线前严禁开风机按钮，否则水倒流，造成风机损坏）

Note: Before adding water, check whether the fan is running smoothly before adding water. After adding water, check whether the conveyor belt motor and water pump are reversed. If they are reversed, stop the machine and change the line. Misconnection is strictly prohibited. (It is strictly prohibited to turn on the fan button before connecting the wires, otherwise water will flow back and cause damage to the fan)

（2）打开总电源开关。总电源开关采用急停开关设计，以防意外。可以对设备紧急停止。

(2) Turn on the main power switch. The main power switch adopts an emergency stop switch design to prevent accidents. It is possible to emergency stop the equipment.

（3）启动风机开关。由于高压气流的原因，启动此开关后，风机可能有一定的噪音，并不影响设备的使用。

(3) Activate the fan switch. Due to high-pressure airflow, after starting this switch, the fan may make some noise, which does not affect the use of the equipment.

（4）启动网带运转开关。（注意：启动网带在启动风机2-3分钟后启动）。

(4) Activate the mesh belt operation switch. (Note: Start the mesh belt 2-3 minutes after starting the fan.).

（5）蒸汽汽源连接蒸汽入口。

(5) The steam source is connected to the steam inlet.

（6）清洗机两边留出很大的清洗区域，方便清洗打扫。

(6) Leave a large cleaning area on both sides of the cleaning machine for easy cleaning and cleaning.

感谢您的阅读，此文的文章来源：全自动超声波清洗机更多的内容和问题请点击：我们会继续努力的为您提供服务，感谢您的支持！

Thank you for reading. The source of this article is: Fully automatic ultrasonic cleaning machine. For more information and questions, please click on: We will continue to work hard to provide you with services. Thank you for your support!